Monday, April 18, 2016

How to repair a leaky exhaust pipe with a butt splice

     When a big leak developed at the flange joint between the catalyst and the resonator on a Pontiac Grand Am, at first it looked like the entire exhaust system might be needed. It could cost hundreds of dollars to replace everything from the manifold back to restore it to the original configuration. I thought of other options. Then it hit me. I could cut the leaky flange joint out with an angle grinder or reciprocating saw and replace it with a butt splice. Hooray. Less than ten dollars bought a reliable fix.

This flange has got to go


                                                      The job at a glance
  • Tools: Angle grinder, reciprocating saw, tape measure   
  • Materials: exhaust pipe sealant
  • Parts: Butt splice, 3 inch, pipe clamps    
  • Cost of parts: Splice: $3.50 Clamps 5.25 for two
  • Time: 1 1/2 hrs.

1) Take some measurements to determine the size of splice needed. We will need to know the outer diameter of the old pipe and the length of splice needed to fit the pipes together. 
2) Remove the bad section of pipe with an angle grinder, reciprocating saw (such as Sawz-all), oscillating cut-off tool (such as Dremel) or hand saws. 


3) Clean up the cut end of the pipe with a file. Remove loose material with a wire brush and clean with solvent.
4) Purchase splice and clamps and test fit. I had to trim the splice to make it fit right. It may be necessary to remove the downstream pipe from hangers to fit. 

I trimmed one end of the splice for best fit

5) Apply a layer of pipe sealant to the outer mating surface of the existing pipe. 
6) Install the splice. Confirm there is maximum overlap at both ends of the pipe to be repaired and the splice. 
7) Clamp the splice into place and bolt down securely.

Nice and quiet and very attractive

8) Test the repair for leaks.

                  

6 comments:

  1. Hi Original Mechanic, where did you buy the Butt splice? I had the same problem you just fixed happen to me today. If you could please let me know I'd appreciate it. Thanks. (I just watched your youtube video and left the same question, I wasn't sure which message you would get quicker, thanks again.)

    ReplyDelete
  2. Dude! Awesome stuff. Please keep writing more things like this.hillsemergencyplumber.com.au

    ReplyDelete
  3. Looking for a Tube Cutting Machine in your area ? Then we are the best for you, who suit your expectations. We have huge experience in this field. We are 100% dedicated to finding you a high quality Tube Cutting Machine.
    If you want to know more, Please check out Cheers Electronic Technical Co.LTD: https://www.terminal-crimping.com/Pipe-Tube-Cutting-Tools.html

    ReplyDelete
  4. I didn't know the actual use of colors on the wires and it always confused me. but thank you for writing such a valuable post with answers to my confusions.Masters Dissertation Writing Services

    ReplyDelete
  5. G`evening! Our service https://topessaybrands.com/review/masterpaper-com-review/ have a large staff of academic writers. Hence, we will be able to choose the most suitable writer for your specific custom paper. Our Essay written papers are not resold as pre-written custom essays, as we are not affiliated with any kind of essay databases, unlike some of our competitors on the writing market.

    ReplyDelete
  6. This comment has been removed by the author.

    ReplyDelete