Tuesday, September 8, 2015

How to remove and install the starter in a 1.8L Toyota Corolla

   This post will cover removing and replacing the starter in a 2010 1.8L Toyota Corolla. This is not a difficult starter to replace for the average home mechanic.

                                                     The Job at a glance
  • Tools: 10,12 and 14mm sockets, 14mm deep well socket, 3/8" ratchet, floor jacks and supports, philips screwdriver  
  • Parts and materials: starter
  • Cost of Materials: approx. $95 to $185 
  • Time: 1 hour 
  • Shop cost: $90-120

Removal

   There are two 14mm mounting bolts for the starter, 180 degrees apart. The lower one is easily accessible but the top one is so close to the dipstick for the transmission that it is very difficult to get tools in there. The good news is that it is easy to remove and get out of the way.
1) Disconnect the battery
2) Jack up the front end and put on supports. A floor jack works great just behind the hook under the middle of the front of the car. Solid supports for the jack stands are just inside of the lower control arms on both sides. 
3) Remove the intake cover. It unsnaps from three ball headed bosses at the corners. 
4) Remove the big air intake hose. This will give access to the upper starter mounting bolt. Loosen the two hose clamps holding the air intake to the air intake plenum and air cleaner. Remove a hose coming in to the left side of the assembly. Then the hose can be lifted up and set out of the way. 


These intake hoses are always in the way. Get it out of there! 

5) Unbolt the bracket holding the transmission dip stick and cooler hoses from the front of the engine. Clean any debris from around the bottom of the stick holder where it goes into the transmission. Then the stick can be moved enough to allow removal of the top starter bolt. The top bolt can be removed from above and the lower from below or above.


Unbolting this dipstick bracket will make the upper bolt easy to remove

6) Break the upper bolt loose with a 14mm deep well socket, a 3/8 to 1/2" socket adaptor and a 1/2" ratchet. 


Removing the upper bolt is the challenge

7) Unwire the starter. Unplug the solenoid control wire. Then unsnap the plastic B+ cover and unbolt the B+ nut with a 12mm 1/4" drive socket and ratchet. 
8) Break the lower starter mounting bolt.
9) Remove the upper bolt
10) Remove the lower mounting bolt while holding the starter and as it comes loose ease it down between the splash shield and frame. 


The lower starter bolt is easily accessible on the Corolla
 Installation

1) With a bolt in one hand, bring the starter up from the bottom and seat in the flywheel opening. Get the bolt started by rotating the starter until it catches in the bolt hole. Turn it in by hand for now until it is flush. 
2) Wire the starter up. Wire the B+ up with the 12mm nut and seat the protective boot. Plug in the solenoid connection.
3) Mount the top bolt by hand as far as possible and then snug it up good with the 14mm deep well socket. 
4) Turn the lower bolt in to final torque with the 14mm socket.  
5) Re- seat the transmission dipstick and mount the bracket with the 12mm socket..
6) Re-mount the air intake hose. Don't forget the small hose coming in from the left. 
7) Snap the intake cover back into place.
8) Lower the vehicle off the stands
9) Wire up the battery
10) Test the starter




                                  

5 comments:

  1. I would test the starter before remounting the large lower splash shield, no?

    ReplyDelete
    Replies
    1. Sorry, that's actually a mistake. There is no large splash shield on this car. I will correct that.

      Delete
  2. The scissor jack is quite simple and will mainly be used for changing tires. It will lift your vehicle on one side to ease the process of replacing your flat tire. This is one of the cheapest options when it comes to jack for the car. It can lift so many weights also. You can also search for best floor jack guide

    ReplyDelete
  3. The article was up to the point and described the information very effectively. Thanks to blog author for sharing an informative post. Mechanics Ellerslie

    ReplyDelete
  4. Rent a Lamborghini from mph club in Miami or anywhere in the U.S. book an exotic car online get it delivered to your door. Rent a Lamborghini

    ReplyDelete