Thursday, October 4, 2018

How to Replace the Water Pump 2.2L Toyota Camry 1997-2001


A major coolant leak signaled that the water pump in a 2001 Toyota Camry had failed. In the 2.2L engine the pump is driven by the timing belt.  This post will cover replacing the entire pump assembly: both pump and housing. The front of the engine must be torn down to replace the pump. Here is a link to a post on front end tear down on this engine:
http://www.originalmechanic.com/2018/05/how-to-replace-timing-belt-1997-2001.html

                                                        The job at a glance



  • Tools:  Floor or other jack, jack stands, 1/4", 3/8" and 1/2" drive metric sockets 10, 12, 14 and 19mm wratches and wrenches, large breaker bar, harmonic balancer remover or other puller, two 6mm x 70mm thread pitch 1.00 bolts.
  • Parts: Water pump and housing assembly
  • Materials: 
  • Time: 3 hours     

Disassembly


1) Remove the alternator, tear down the front of the engine and remove the timing belt. See link above.

2) Drain coolant by opening the radiator petcock. But expect some minor loss of coolant during later parts of this procedure.

3) Remove the timing belt tensioner and spring.



4) Remove the idler as it is in the way of removal of the pump.

5) Remove the alternator mounting bracket (12mm) and separate the connected  wiring.

6) Remove the upper radiator hose by pulling the clamp back and pulling it off. This is where some coolant loss will occur.

7) Remove the plastic piece of pipe housing the thermostat (two 10mm nuts) from the water pump.



8) Remove two 10mm nuts holding a bracket for the two outlet pipes to the right of the pump.
I used a 1/4" ratchet and 2 inch extension and a "U" adapter to get into the tight lower spot.



9) Unbolt three 10mm water pump to engine mounting bolts. These are easy to access but note, several nearby bolts on the pump only hold the two pieces of the pump together. Don't remove those.

View of mounting nuts shown on the new pump


10) Pull the pump off the engine. It may take some jiggling to separate the pump from the outlet pipes. 

Installation


1) Seat the small o-ring on the upper steel outlet pipe. Just a touch of grease on the outside diameter of the o-ring will help new pump slide over it.



2) Seat the larger o-ring into place in the groove on the pump where it mounts on engine.

3) Seat the flange-type gasket on the water pump where the lower steel pipe mounts on the pump housing. 

4) Check the engine mating surfaces with the pump and clean if necessary.

5) Mount the pump. Slide it over the pair of outlet pipes. When seated fully, turn in the three 10mm mounting bolts, evenly by hand. Snug up. Tighten the two 10mm lower outlet pipe nuts. Torque the three mounting bolts now to 78 in lbs.




Torque the three mounting bolts to 78 in lbs

6) Mount the thermostat housing and thermostat with two 10mm nuts. This is a good time to install an new thermostat. Do not over torque these on the plastic housing. 

7) Install the upper radiator hose and clamp.

8) Mount the alternator bracket, loosely for now, with a 12mm bolt.  This will fully torqued later when the alternator is mounted. 

9) Reinstall the timing belt and the rest of the front of the engine. 

10) Test for leaks. 


9 comments:

  1. Very nice post , Blog commenting is useful for SEO ,Thanks for sharing your ideas you cover some good tip here........! buy ipamorelin peptide


    ReplyDelete
  2. This comment has been removed by a blog administrator.

    ReplyDelete
  3. This comment has been removed by a blog administrator.

    ReplyDelete
  4. This comment has been removed by a blog administrator.

    ReplyDelete
  5. This comment has been removed by a blog administrator.

    ReplyDelete

  6. If You are looking for something different, then I am ready. Escorts Service in Jaipur I am well educated, have an open mind and have the girlish charm that Is fun and easy to be found. You will always find me smart, clean and fresh as I am very conscientious about my hygiene and I expect all my clients to reciprocate in the same manner. Check our other Services...
    Escorts Service in Jaipur
    Escorts Service in Jaipur
    Escorts Service in Kolkata
    Escorts Service in Kolkata
    Escorts Service in Kolkata

    ReplyDelete
  7. As with most things, you will get what you pay for so try and choose the best possible lock for your bike. bike air pump

    ReplyDelete
  8. Thanks for your help finally got it aligned rotated it twice and it lines up perfectly, but there is still a little too much slack, what do i do about this? I made sure the belt is routed correctly also.

    ReplyDelete
  9. How to win at Roulette - Jeopardy.com
    Roulette is 부천 출장마사지 a 나주 출장마사지 great casino game 태백 출장샵 for beginners and experienced 과천 출장마사지 players alike. Read 상주 출장마사지 our guide to learn basic strategy and strategy,

    ReplyDelete